How to
program BMW F series FA via E-SYS?
Recently when I asked help
about how to change my BMW F-series FA on the forums, some friends offer me the
useful messages, and here I will
share with other friends. It is a little work through my car with cheap ENET E-Sys cable.
Below
are detailed steps:
1. Start E-sys program,
and connect to car by clicking icon at the top.
2. Select your car, and
click connect. Select interface depending on interface you will be using. If
you use ENET cable then select connection via VIN at the bottom.
3. Go to expert mode > coding. Click read
under vehicle order to read FA from car. Click edit.
4. Screen will automatically change to
FA-editor. Right-click on FA, and choose “calculate FP”.
5. Once finished, vehicle profile is shown on
right. Expand FA List on left, to SALAPA-element.
6. Delete/add FA from the bottom left window,
and click apply changes icon.
7. New FA must be verified before it can be
written to car. Right-click FA and calculate FP again. If FA entered is wrong,
error will be shown. For example, “DDD” is not correct FA and E-sys will
display error message. After FP is calculated, save the new FA.
8. Go to Expert mode > VCM. Load your
saved FA file, right-click on FA and calculate FP again.
9. Click VCM master tab, and click write FA
FP. New FA will be written to the car.
10. Click “read FA FP VIN” button and check
FA to make sure changes are saved to the car.
That’s all, It
only takes a few minutes to do the job.
没有评论:
发表评论